Fittings List for a 1:24th scale BPB co
63ft TYPE 2 "WHALEBACK" A/SRL
Please note! ALL fittings are sold as cast and are an each price unless sold as a set.
| Code | Picture | Description | Cost
EACH |
Amount Required for Boat |
| A/SR:01 | Picture to be displayed when available | PROP SHAFTS “sliver steel” 4 mm dia x 255mm shaft/230 mm brass tube |
£ 5.00 each |
1 |
| A/SR:02 | Picture to be displayed when available |
|
||
| A/SR:03 |
 |
20mm Ammo lockers "FOR LATER BOATS" "ON STERN" |
£ 2.00 each | 2 |
| A/SR:04 | Picture to be displayed when available |
Vac-Formed Wheelhouse |
£12.50 | 1 |
| A/SR:05 |
|
20mm
OERLIKON CANNON ON It's BASE
"FOR LATER BOATS" "Additional parts need to made and fitted by the modeller" (figure not included) |
£13.00 each | 1 |
| A/SR:06 |
 |
Resin Rudder with Brass shaft and tube tube | £ 3.00 each | 1 |
| A/SR:07 | Picture to be displayed when available | Fuel vents "Set of 2" | £ 1.50 | 1 set |
| A/SR:08 | Picture to be displayed when available | Air vents16mm dia x 35mm high | £ 1.00 each | 2 |
| A/SR:09 | Picture to be displayed when available | Air vents16mm dia x 22mm high | £ 1.00 each | 2 |
| A/SR:10 |
see HD15 |
Anti flak/shrapnel mats 32mm x32mm double mat | £ 0.40 per side | ? |
| A/SR:11 |
see HD15 |
Anti flak/shrapnel mats 64mm x32mm double mat | £ 0.80 per side | ? |
| A/SR:12 |
 |
Fore deck hatch | £ 1.50 each | 1 |
| A/SR:13 | Picture to be displayed when available | Engine room hatch | £ 2.00 each | 1 |
| A/SR:14 | Picture to be displayed when available | Aft deck hatch | £1.00 each | 1 |
|
A/SR:15 |
Picture to be displayed when available | Wheel house top hatches | £ 1.00 each | 2 |
|
A/SR:16 |
Picture to be displayed when available | Rope coils | £ 2.00 | 1 set of 3 |
Vac-form wheelhouse 63ft "Type 2" Air/Sea Rescue Launch @ £15.00 +P&P
We have re-tooled the vac-formed wheelhouse with the correct roof radius and cabin length.
Please note! Figure, gun site and ammo drum are not included in our gun kit. It is hope to sell the gun complete with figure in the near future.
Parts needed to be made by the modeller for 20mm cannon are : AMMO DRUM, SITE ARM, SITE AND HANDLE.